Where should clamps be connected to the PV module?

When the mechanical load pressure is ±2400Pa, Clamps should be connected to the module between 400 and 500mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *NOTE: We need two or three support rails below the PV module to make sure the module have a good mechanical load performance.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.

How do I install a double glass PV module?

Insert the PV module into the clamp, and make sure the module edge touch to the EPDM closely and then tighten the nut with uniform torque values using a qualified torque wrench to ensure the double glass module is firmly secured. Trina suggests using M8 bolts to affix the double glass modules onto the clamp.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

How to install a PV module?

Remove the bottom connector parts. Connector parts : M8 Nut 、spring washer and washer. Put the clamp bolts into the installation holes, and then tighten the nuts. Insert the PV module into the clamp, and then tighten the nut. M8 ss304(16N· m~20N· m) Insert clamp into the connector racking.

Which Racking clamps should I use for Trina Solar racking?

For C structure steel type 1 racking, due to the amount of space inside the racking section, many choices are available including T-shape nuts. Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module.