How to install a new belt on a DeLuxe Van de Graaff generator?

INSTRUCTIONS: Following is the suggested procedure for installing a new belt (P6-3300-1) on the Deluxe Van De Graaff Generator (P6-3300 and P6-3500). Be sure your hands are clean and dry before proceeding. 1. Unplug the line cord from the electrical outlet. CAUTlON: Do not proceed until this is done. 2.

How do you fasten a new belt?

INSTALLATION The fastening method between the new belt and the old belt, or cable, must be strong enough to overcome all frictional forces of the belt against the idlers and pulleys, the gravitational forces of any changes in elevation, and the inertia forces involved with the start of the pull. We

How do you tighten a fan belt?

Tighten the locking nut or bolt and the lock washer to 455ft-lb (61bm) of torque so that the tensioner or bracket is fastened. 1. Loosen the large locking nut on the fan hub or fasten the fan hub to the bolt on the mounting bracket. After this work is done, the fan hub will deviate. 2. Turn the adjusting bolt to increase the tension of the belt. 3.

Where should a new belt be installed?

Maintenance teams generally prefer to have the new belt installation point at the tail pulley however, too many systems have walls or other conveyors at this point. When this occurs, the installation point may have to be GKVJGTWPFGTQTQXGTVJGU[UVGO.

How do you splice a ucxguvkogcpfgzrgpug belt?

Not only does this UCXGUVKOGCPFGZRGPUG If the optimum splice station is different than the installation point, a means of moving the two ends of the belt to the splicing area must be used. Frequently, this is accomplished by temporarily joining the belt ends together and using the system drive to move the belt.

How to install Graaff generator?

Graaff Generator (P6-3300 and P6-3500). Be sure your hands are clean and dry before proceeding. 1. Unplug the line cord from the electrical outlet. CAUTlON: Do not proceed until this is done. 2. Carefully remove the top half of the dome and set it aside. 3. Remove the six cabinet screws from the front and back sides and the top of the base.