What are the requirements for a PV installation?

Virtually all domestic PV installations will fall under the scope of Part P. Part P requires the relevant Building Control department to be notified and approve the work. There are two routes to comply with the requirements of Part P: Notify the relevant Building Control department before starting the work.

How should a PV system be designed & installed?

From the outset, the designer and installer of a PV system must consider the potential hazards carefully, and systematically devise methods to minimise the risks. This will include both mitigating potential hazards present during and after the installation phase.

Are there any UK standards relating to a PV installation?

While many UK standards apply in general terms, at the time of writing there is still relatively little which specifically relates to a PV installation. However, there are two documents which specifically relate to the installation of these systems that are of particular relevance:

Who should check the roof structure of a solar PV system?

5.9.4 The MCS Contractor shall ensure that the roof structure is checked by a suitably competent person to ensure it can withstand the loads imposed by the solar PV system. 5.9.5 For the typical roof structure types shown in Table 1, the calculation methodologies given should be used. qualified structural engineer shall be consulted.

How should a purlin be positioned?

ghtened to the required torque settings. Pan lling should commence from east to west. All panel clamps and fixings will come pre-assembled, the diagrams be ow are for representative purposes only.Your choice of panel will have n effect on the position of the purlins. Please ensure your purlin spacing is cor

Are all PV products covered by IEC61730 'photovoltaic (PV) module safety qualification?

In future it is expected that all PV products will increasingly be covered by International standard IEC61730: 2004 ‘Photovoltaic (PV) module safety qualification’.